Quickie Pulse Service Manual download pdf (Page 24)

PULSE 6 SERVICE MANUAL

PAGE 2.1

2009SUNRISE MEDICAL

Section 2

VR2 Remote Controller Display

Indicates that the wheelchair is locked. To unlock the wheelchair,

deflect the joystick forwards until the control system chirps. Then deflect the joystick in reverse until

the control system chirps. Release the joystick, there will be a long beep. The wheelchair is now unlocked.

To lock the wheelchair, while the control system is switched on, depress and hold the on/off button.

After 1 second, the control system will chirp. Now release the on/off button, deflect the joystick forwards

until the control system chirps, and deflect the joystick in reverse until the control system chirps. Release

the joystick, there will be a long beep. The wheelchair is now locked.

This indicates that the chair is charging . The chair will be ready to drive as soon as the charger is unplugged.

This indicates that all is well.

The control system is functioning correctly, but you should charge the battery as soon as possible. At 22 V, the red

light starts to blink. Each bar represents a .5V value. The controller requires 18V to start and a minimum of 16V to

work once started

Indicates the wheelchair batteries are being charged with the offboard charger. You will not be able to drive the

wheelchair until the charger is disconnected and you have reset the control system by switching off the

power and then powering up again.

The control system has "gone to sleep" because the wheelchair has not been driven for a period of time.

The time period depends on the programming of the system. To re-start, reset the system by switching

off the power and then powering up again.

Make sure the Joystick is completely released (Joystick should be centered and/or nothing is pushing the gimbale

out of center). The control system safety circuits have been activated and the control system has been prevented

from moving the wheelchair. This indicates a system trip, i.e. the VR2 has detected a problem somewhere in the

wheelchair's electrical system. Please refer to Section 3 (VR2 Controller Diagnostics).

The Maximum Speed Indicator Ripples

The Maximum Speed Indicator Flashes

Battery Gauge is Steady

Battery Gauge Flashes Slowly

Battery Gauge Steps Up.

Battery Gauge Blinks Once Every 2.5 Seconds

Battery Gauge Flashes Rapidly

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 61 62

No comments

Quickie Pulse Service Manual Page 24