Quickie Pulse Service Manual download pdf (Page 24)

PULSE 6 SERVICE MANUAL

PAGE 1.1

SEPT 2011SUNRISE MEDICAL

Section 1

Battery Connection Test

1. Check that the female VR2 Bus plug on

the chair has voltage. Set the meter to DC volts

and measure pins 4 (using the red lead of the

meter) and 1 (using the black lead of the meter)

as shown in (fig 1.1.1)

Fig 1.1.1

Fig 1.1.2

2. If the voltage meter reads full voltage, then

replace the joystick module

If the voltage meter reads zero voltage measure

the corresponding pins on the VR2 controller as

shown in (fig 1.1.2).

If the voltage meter reads full voltage, then

replace the jumper cable. If the voltage meter

reads zero, then measure the Battery Connector

as shown in (fig 1.1.3) If the voltage meter reads

full voltage, replace the controller, or proceed to

the next step.

Troubleshooting: No Power

Fig 1.1.3

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 71 72

No comments

Quickie Pulse Service Manual Page 24