Quickie Hula Technical Information download pdf (Page 28)

28 HULA

Rev.1.0

6.8 Standard Seat Depth Adjustment

Remove the 5mm depth adjustment bolts from both 1.

sides of the seat, (Fig.6.11).

Slide the rear backrest and armrests into the desired 2.

seat depth position. Reference seat depth position

patterns (A), (Fig.6.12).

Replace both sets of depth adjustment bolts. 3.

Use 20 Nm or 177lbf/in of torque, (Fig.6.13).4.

NOTE: Depending on the seat depth, the side guard

position may have to be moved, (see section 5.8.1-

Fig.5.37).

6.9 Backrest Angle Adjustment -4° to +12°

1. Remove the 5mm backrest bracket index bolts (A) on

both sides of the backrest. Loosen the 5mm backrest

bracket pivot bolts (B) on both sides of the backrest.

NOTE: The index bolt (A) may be in a different starting

position than shown below in Fig.6.14.

NOTE: Maximum recline angle on your Quickie Hula is

12 degrees. A feature has been added to the backrest

recline bracket to limit the maximum recline to 12 degrees,

(Fig.6.14.1).

DANGER!

Do not remove the factory fitted recline limitation stud.

Removing the stud could allow an unsafe backrest set up

leading to possible instability of the powerchair which may

in turn lead to injury or death.

Fig. 6.11

Fig. 6.14

Fig. 6.12

Fig. 6.13

2. Tilt the backrest assembly forward or backward to the

desired angle.

NOTE: See angle configurations on next page, (Fig.6.15).

Fig. 6.14.1

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 55 56

No comments

Quickie Hula Technical Information Page 28