Quickie Hula Technical Information Page 32

  • Download
  • Add to my manuals
  • Print
  • Page
    / 56
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 31
32 HULA
Rev.1.0
6.13 JAY backrests
The standard backrest assembly will allow the fitting of a
JAY backrest, which is available as an optional extra.
6.14 Headrest
To fit the Standard headrest, fit the location bracket to
the push handles, using the screws and nuts supplied,
ensuring that they are fully tightened.
Adjusting the Headrest.
The headrest height is changed by loosening the
adjustment knob and sliding the inner vertical tube to the
desired position and tightening the knob. The headrest
to seat depth is adjusted by loosening the 6mm Allen
screws and moving the hinge to the desired position
and then tightening the screws securely. To adjust the
headrest angle, loosen the screws at the headrest
upholstery, position the headrest as required and tighten
the screws securely. (Fig.6.30)
Fig. 6.30
7.0 Control System
7.1 VR2 control system information (Fig.7.1)
On/off button:
The on/off button applies power to the control
system electronics, which in turn supply power to the
wheelchairs motors.
CAUTION!
Do not use the on/off button to stop the wheelchair
unless there is an emergency. (If you do you may
shorten the life of the wheelchair drive components)
Battery gauge:
The battery gauge shows you that the wheelchair
is switched on. It also indicates the status of the
wheelchair. Refer to chapter 8.
Locking/unlocking the wheelchair:
The VR2 control system can be locked to prevent
unauthorised use. The locking method is via a sequence
of key presses and joystick movements as detailed
below.
To lock the wheelchair:
While the control system is switched on, depress •
and hold the on/off button
After 1 second the control system will beep. Now •
release the on/off button
Deflect the joystick forwards until the control system •
beeps
Deflect the joystick in reverse until the control •
system beeps
Release the joystick, there will be a long beep•
The wheelchair is now locked•
To unlock the wheelchair:
Use the on/off button to switch the control system •
on. The maximum speed/profile indicator will be
rippling up and down
Deflect the joystick forwards until the control system •
beeps
Deflect the joystick in reverse until the control •
system beeps
Release the joystick, there will be a long beep•
The wheelchair is now unlocked•
Page view 31
1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 55 56

Comments to this Manuals

No comments