Quickie Jive Specifications download pdf (Page 19)

Quickie Jive 19

5.5 Drive wheel suspension Jive F/R

The Jive F/R has an effective and adjustable drive wheel

suspension system as a standard feature. To match your

requirements on drive comfort, the tension of the springs

at the damper can be adjusted.

Turning the aluminium ring on the bottom of the spring

downwards will soften your ride, adjusting the aluminium

ring in a higher position will harden it. This option is

to be used to match the different user weights to the

suspension system. (Fig. 5.7). We recommend the

suspension adjustments are done equally on the left and

right side of the chair.

5.6 Control joystick unit position

Depending on your chosen control system, there are two

principles of control systems: Quickie VR2 and Quickie

R-net controls (for details please see the controls section

7). The remote is mounted on a sliding mechanism

which enables the control to be moved forwards and

backwards.

Undo the locking screw, (Fig.5.3).•

Slide the control arm either out or to it’s new position, •

(Fig.5.4).

When the most comfortable position has been selected,

secure the slider by tightening the locking screw. Ensure

the locking screw is fully tightened prior to use and

especially when transporting your wheelchair.

5.7 Arm Rests

5.7.1 Arm Rests-removing

The arm rests on both sides of the wheel chair can be

removed to allow side transfer.

Please refer to your appropriate arm rest type.

For single post arm rests:

Undo the finger wheel at the bottom of the post, •

(Fig.5.1).

Lift the arm rest out of the receiver, (Fig.5.1).•

Reclining arm rest:

Undo the star wheel at the bottom pivot of the arm •

rest.

Lift the arm rest up out the receiver. You can now flip •

it backwards, (Fig. 5.8).

For F-XL and Recaro:

Single Post Armrest:

Release the handle screw on the side of the armrest

receiver and remove armrest (Fig. 5.8.1).

5.7.2 Arm Rests-replacment

Please refer to your appropriate armrest type.

Single Post Armrest Jay- Jay Comfort:

Place the armrest tube in the armrest receiver. •

Fix and tighten the finger wheel, (Fig. 5.4).•

Reclining armrest:

Move the arm rest from the flip back position and place

the post into the receiver.

Tighten the star wheel on the receiver to lock the post

into position, (Fig. 5.8).

5.7.3 Adjusting the armrest width (Jay and Jay

Comfort Seat only)

To adjust the width:

Loosen the four screws (13mm spanner) as shown in •

(Fig. 5.9).

Move the armrest receiver brackets to the desired •

position, (Fig. 5.10).

Tighten the screws firmly prior to use. •

NOTE: Please check that the new arm rest

position does not interfere with any seat positioning

modules, Lift-Tilt etc.

Fig.5.7

Fig.5.8

Fig.5.9

Fig.5.10

Fig.5.8.1

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 59 60

Comments to this Manuals

No comments

Quickie Jive Specifications Page 19

Comments to this Manuals

Related products and manuals for Unknown Quickie Jive